DIRECTIONS FOR MANUAL CLEANING:
1. Use approximately 1/2 oz. to 1 oz. of concentrated Nano-Wash to
two gallons of water.2. Apply solution liberally with a sponge
or towel. Rub slightly to remove stubborn dirt.3. Wash one section
of vehicle at a time. Then rinse thoroughly with clean water before
area dries to remove dirt and soil.4. Properly rinsed, the vehicle
will drain dry. Depending on water conditions you may want to use
a chamois or specialty squeegee.
DIRECTIONS FOR FOAMER/WASHER CLEANING:
1. Thoroughly rinse surface prior
to cleaning.2. Add Nano-Wash into chemical reservoir and adjust dilution
system to draw 1-2 oz. per gallon.3. Foam at low pressure. Always start
with the roof followed by the side walls from top down.4. Rinse with
water immediately. Do not allow product to dry on surface before rinsing.5.
If surface is very dirty agitate before rinsing with a brush or sponge.
